What should I do if I see
a "Memory Full" or "Memory Almost Full" warning message?
This indicates
that the RoadRelay has reached or has come close to reaching its
maximum data memory capacity and the data should be extracted from
the RoadRelay or it may be lost. Perform a data extraction using
PowerSpec software for RoadRelay 5 or INFORM/INSPEC software for RoadRelay 4 or reset the
trip information
to remove the data from the RoadRelay. To
reset the RoadRelay 4 trip information you must press key 6 (Pages), scroll down
using key 7 (down arrow), and select the reset trip option (press the
enter key).
I am an owner/operator
and my RoadRelay is set to fleet mode. How can
I
change it?
You must use the PowerSpec software to turn fleet mode off and enable Owner/Operator mode.
How do I change the language
being displayed?
For RoadRelay 5, select the Configuration & Settings (Wrench and Hammer)icon, then select the Driver icon, then select the Languages option and select the language you want (press the enter key). For RoadRelay 4, press key 8 (question mark) and select the language you want (press the enter key).
How do I change the units
of measure being displayed?
For RoadRelay 5, first select the Configuration & Settings (Wrench and Hammer) icon, then the RoadRelay Configuration icon, then select the Units option and select the units you want displayed. For RoadRelay 4, press key 5 (front panel) to reach the configuration screen that allows you to access the menus for selecting units of measure.
How
do I change the vehicle setup for a heavy-duty or RV application?
For RoadRelay 5, select the Configuration & Settings (Wrench and Hammer) icon, then select the RoadRelay configuration icon, then select the Vehicle Setup option and select the vehicle configuration you want (press the enter key). For RoadRelay 4, press key 5 (front panel) to reach the configuration screen, then select the vehicle setup option to change the current vehicle configuration (press the enter key).
Where
do I find the software version in my RoadRelay?
For RoadRelay 5, select the Configuration & Settings (Wrench and Hammer) icon, then select the RoadRelay configuration icon, then select the Software Version option. For RoadRelay 4, press key 5 (front panel) to reach the configuration screen, then select the software version option (press the enter key).
The RoadRelay Fault Table is displaying SPN, FMI (or SID, PID) for faults. How do I convert this to real Cummins Fault Code?
QuickServe Online contains a simple to use SPN/FMI to Cummins Fault Code cross reference. Log into QuickServe Online, select the “Service” tab, then under the “Related Information” section, select “SPN/FMI to Cummins Fault Code cross reference”. Visit the QuickServe Online website by clicking here or contact your Cummins distributor about access to Cummins QuickServe Online.
I want to use the Anti-theft feature of the Cummins Engine and RoadRelay. How do I do this?
You may download instructions on how to enable the Anti-theft feature in the Cummins Engine ECM by clicking here.
I
am interested in developing an application that communicates with
the RoadRelay through the open interface. How do I obtain the information
I need to do this?
You may
download the RoadRelay open interface specification by clicking here.
